Angle Tilt Fixtures
TMBolt these Universal Aluminum Tilting Bars to ANY racks. Tilt, Fan, Dense Pack, Angles, Straight Up and Z or L Shots
Bolted to any rack corner through predrilled holes. Use in place of end boards when building racks. Use with end supports for tilting and fanning at 5, 10, 15 or 20 degrees. Can also be used straight up in dense packs. Use up to sixteen 3 inch racks with just one end support.
Maximize the versatility of your show.
Fastener pins & clips
pins pass through perforated end
supports and in the top and bottom of each tilting bar.
2” x 5”, long enough to lock two tilting bars and one end support. These are held in place with clips.
Tilting bars work on any different width or height racks. No big protrusions like ‘eye bolts’ to get in the way in shipping and storage. Bars strengthen racks. Washers before clips must be added for safety.
AdaptiveTiltFireTM racks. No need to purchase tilting bars, they are built in. Optional eye bolts for independent conventional use can remain in place when used in the tilted mode with hardware.
AngleTiltFixtureTM tilting bars straight up in “Z”ed “L” shots using only pins and clips. No Perforated End Supports!